FrontHandlebars, F forks, headlights, etc.

【Headlight】

◯7-inch original headlight for Springer. Heat-treated

【Handle/Handle Area】

◯The handlebar is a one-off stainless steel hand-bent, using a dog bone riser for Harley.

“Handle Lock Weld On Kit”

〇It is newly installed by welding to the lower part of the stem, which is inconspicuous and easy to operate.

“MOTOR ROCK Decompression lever”

〇 A decompression lever directly attached to the engine to simplify the handle area. (The one on the vehicle is an old model)

【Front Turn Signal】

◯Guide Type Turn Signal.

【Speedometer】

“Mechanical Speedometer 60mm Black Panel 1:4”

◯Embed the mini meter into the tank.

CenterTank, oil tank, seat, step, muffler etc.

【Muffler】

“Exhaust Pipe Flange Set for One-Off Pipe Production”

〇A one-off made using a convenient kit for the base mouthpiece. An upswept megaphone muffler.

【Seat】

◯A custom-made solo saddle seat with seat rail drop processing. It is installed with a soft ride that is hard to bottom out due to changes in mounting angle and spring input position.

“Welding nut non-through M8 2p”

〇Used on the frame side as a seat spring receiver.

【Electrical Equipment】

◯ Repurposing the battery box of a side valve into an electrical equipment case.

『IC blinker relay wide range specification』

〇 A wide-range turn signal relay that can handle 1-150 watts without any problem, even for LED turn signals. It can also be used as a replacement for the original relay.

【Gasoline Tank Installation】

◯ The tank is divided and processed, with a speedometer embedded.

“Welding nut non-through M8 2p”

〇 Drill a hole in the gasoline tank body and insert and weld. It’s non-penetrating, so it won’t leak. Used on both sides.

“Weld tab M size 4.5mm thickness 2p”

“Weld tab M size 6mm thick steel 2p”

〇 Enlarge the hole diameter and change to a rubber mount specification to hold the non-penetrating nut. Used on both sides.

“Weld tab L size 4.5mm thick steel 2p”

〇 Used for the rear installation of the gas tank. This also has an enlarged hole diameter and is used with a rubber mount.

【Engine Area】

“Breather filter SR400/500”

〇This is a filter kit needed when removing the original air cleaner.

【Drive System】

『Front sprocket SR400/500 428-19』

〇A durable replacement sprocket made of steel.

RearFenders, rear shocks, swingarms, etc.

【Rear Shock】

“280mm G-Suspension”

〇A rear shock that is about 4cm down on a swing arm extended by 7cm. It moves well among the low-down suspensions.

【Rear Fender】

◯One-off XL fender.

【Rear Turn Signal】

◯Guide Type Turn Signal.

【Drive System】

“Rear sprocket SR400/500 428-56”

〇A durable sprocket made of steel.