#19 SR400Custom Report
A classic low-down bobber.
We built the entire thing around the gas tank that the owner brought in.
Custom List
FrontHandlebars, F forks, headlights, etc.
【Front Tire】
〇A classic watermelon pattern, a vintage style tire with height.
【Headlight】
“5.75 inch Bates Light Black Body/Chrome Rim”
〇A classic headlight that matches well with the SR’s vehicle size and fork width. It is installed with a headlight stay that mounts low and close to the vehicle body.
【Handle/Handle Area】
“Amal type throttle holder, general purpose (for 7/8″)“
“Amal type slot wire 900mm ’88~’08“
“Brake wire/100mm 200mm 300mm 600mm SR400/500 #SR400/500“
“Clutch wire/300mm 200mm 100mm standard SR400/500 ALL YEARS“
〇We are using long cables for the simple throttle.
“MOTOR ROCK Decompression lever“
A decompression lever directly attached to the engine to simplify the handle area. (The one on the vehicle is an old model)
【Front Blinker】
“Small Bullet Turn Signal Chrome 4pcs SET General Purpose“
〇A classic among classics. A chopper-style blinker.
“SR400/500 Bottom Mount narrow blinker stay“
〇A stay to attach a 10mm blinker to the bottom of the frame.
【Speedometer】
“Mechanical Speedometer 60mm Black Panel 1:4“
〇A standard small meter. It comes with a trip meter.
CenterTank, oil tank, seat, step, muffler etc.
【Muffler】
◯ We combined a universal item for production with a semi-up exhaust pipe. It has good exhaust and sound.
【Electrical Equipment】
“IC blinker relay wide range specification“
〇A wide-range blinker relay that can handle 1-150 watts without any problem, even for LED blinkers. It can also be used as a replacement for the original relay.
〇A battery-less kit that is made entirely in Japan.
【Gasoline Tank Installation】
◯ Customer-provided gasoline tank.
“Welding nut non-through M8 2p“
〇 Drill a hole in the gasoline tank body and weld it in. It’s non-penetrating, so it won’t leak. Used on both sides.
“Weld tab M size 4.5mm thickness 2p“
〇 Enlarge the hole diameter and change to a rubber mount specification to hold the non-penetrating nut. Used on both sides.
“Weld tab L size 4.5mm thick steel 2p“
〇 Used for the rear installation of the gas tank. This also enlarges the hole diameter and uses it as a rubber mount.
【Engine Area】
〇A filter kit needed when removing the original air cleaner.
【Drive System】
“Front sprocket SR400/500 428-19“
〇A durable replacement sprocket made of steel.
RearFenders, rear shocks, swingarms, etc.
【Rear Shock】
〇A rear shock that lowers by about 4cm. It moves well among low-down suspensions. (Removal of the original chain case is necessary)
【Rear Tire】
〇A classic vintage style watermelon pattern. It’s a rear tire with height and volume.
【Rear Turn Signal】
『Small Bullet Turn Signal Chrome 4pcs SET General Purpose』
〇A classic among classics. A chopper-style turn signal.
『Rear Bottom Mount Turn Signal Stay』
〇A stay to attach the turn signal to the swing arm.
【Drive System】
“Rear sprocket SR400/500 428-56“
〇A durable sprocket made of steel.
〇A replacement drive chain with built-in O-rings.
※Parts Reference may show similar products or products with additional processing.