#67 VULCAN

Custom Bike

#67 VULCANCustom Report

70’s style Vulcan.

We have created it in a simple old school style without using trendy items or doing anything unnecessary.

Not only the exterior, but also the engine has been replaced from the normal 400cc to an 800cc imported from overseas, and has obtained official vehicle inspection.

The carburetor is carefully adjusted. It’s fast and in good condition.

The way the mini disc is attached is set so that the front fork sinks firmly when braking.

Since it’s such a bike, we are particularly careful about adjusting those settings.

 

Cookie consent is required to display this video.

Custom List

FrontHandlebars, F forks, headlights, etc.

Front Fork Area

◯The front fork is a 22.5 inch over made by “MC Peckers”. Even with this length, it is hard to yaw, and the double-structured spring prevents the fork from towering even in curves. The spring rate is appropriate and the movement is good, I think it’s an excellent quality springer. Originally for Harley, I made a neck shaft for Vulcan and diverted it.


Front Wheel

◯19-inch Invader wheel, mini disc kit also made by MC Peckers. (We also handle it at 2%ER)


Headlight

◯ Deadstock Dixie square light. The light stay is a one-off made by combining five stainless steel plates.

Similar products are here↓

Vintage Style Square Headlight General Purpose


Handle/Handle Area

◯A ‘one-off handle’ made of stainless steel, hand-bent and welded, in line with the main fork of the Springer. It was produced based on discussions with the owner.

◯The mirror stay is directly attached to the handle, and a Grimeca brake master is used.


Front Blinker

Small Bullet Turn Signal Chrome 4pcs SET General Purpose

〇A classic among classics. A chopper-style blinker.


CenterTank, oil tank, seat, step, muffler etc.

Muffler

◯Goose pipe style upswept muffler. It was custom made with stainless steel material.


Seat

BATES Type Genuine Leather Solo/Pillion Set Vertical Tuck Roll

〇A comfortable seat set made of genuine leather. The spring input position and angle are set, and the pillion pad mounting position is set in a unique, fatigue-resistant setting by 2%ER.

Welding nut non-through M8 2p

〇Used by welding to the frame side as a seat spring receiver.


Seat Rail

◯We have remodeled the seat subframe to be narrower and more rigid. We will manufacture it with just enough clearance when assembling the rigid suspension, and ensure it passes vehicle inspection.


Gasoline Tank

◯The gasoline tank is a Sportster. It has a design paint with a gradient applied to a silver flake base.


Electrical Equipment

IC blinker relay wide range specification

〇A wide-range turn signal relay that can be used without any problems with LED turn signals, supporting 1 to 150 watts.


  • RearFenders, rear shocks, swingarms, etc.

    Rear Fender/Sissy Bar

    ◯The one-off flat fender with solid reinforcement on the back plate is finished in chrome. The sissy bar is also one-off. We have recreated the design of the “Dual Loop” from the past using square bars.


    Tail Lamp

    〇The tail lamp is a box tail. It suits this type of chopper very well. ( Click here for related tail lamp parts )


    Rear Blinker

    Small Bullet Turn Signal Chrome 4pcs SET General Purpose

    〇A classic among classics. A chopper-style blinker.

    ※Parts Reference may show similar products or products with additional processing.