Follow 2%er
Home » #56 DRAGSTAR 400

#56 DRAGSTAR 400

Custom Bike

#56 DRAGSTAR 400Custom Report

A Dragstar in Frisco style, carefully crafted in consultation with the owner.

The front area is slimmed down using parts from an SR. The “fork joint” is slightly extended.

The vehicle silhouette is crafted with 21-inch/16-inch front and rear wheels, and short rear shocks.

The Dragstar 400, which has a large and bulky impression in its normal state, is made simple and slim.

Finished by using bolt-on parts and creating one-off parts at key points.

 

Cookie consent is required to display this video.

Custom List

FrontHandlebars, F forks, headlights, etc.

【Front Fork Area】

◯ The front area is SR. It gives a slim impression with processed recycling.

“2%er 10cm long Joints for Front Fork (pair) [SR400/500]“

〇 High-quality stainless steel fork joint.

“Fork boots, general-purpose“

〇 Universal classical fork boots.

【Front Wheel】

“SR400/500 21inch kit for front“

〇A wheel kit that results in a narrow, large-diameter, sharp style.

【Headlight】

◯The headlight is a deadstock “Mirror-made square light”. It is a one-off light stay that is mounted a little higher.

 

【Handle/Handle Area】

◯A one-off handle made of hand-bent stainless steel. It is made to fit the owner’s physique.

“Amal type throttle holder, general purpose (for 7/8″)“

◯The change to an Amal throttle has resulted in an even simpler finish than usual.

“Handle Lock Weld On Kit“

〇A new handle lock has been installed in a discreet location under the under bracket.

【Speedometer】

“Minimeter Fork Mount Kit SR400/500 XS650 #2%er Original #SR400/500“

◯ You can set the meter in a visible place without disturbing the style, with free rotation and up and down sliding.

CenterTank, oil tank, seat, step, muffler etc.

【Muffler】

◯The high-pipe muffler in Frisco style is a one-off item. It’s a part where the owner has particularly paid attention to.

【Step】

◯The mid-high step is made by Motor Garage GOODS. It’s convenient.

【Seat】

◯A one-off seat with a button-down old school design. It’s a design that resonates with the “Original Seat”. We are making a base plate so that you don’t have to worry about clearance with the fender.

【Gasoline Tank Installation】

◯ A one-off coffin tank made from a single sheet of iron to fit the frame width of the Dragstar.

【Electrical】

◯We have concentrated all the switches on the side cover made by GOODS as well.

    • RearFenders, rear shocks, swingarms, etc.

    【Rear Wheel】

    ◯The rear wheel is now 16 inches. This increases the tire options and makes it slimmer.

    【Rear Fender/Sissy Bar】

    ◯The round top cycle fender and fork type sissy bar are one-off.

    【Tail Lamp】

    〇 Side-mounted “Old Speed Factory Tail Lamp”.

    ※Parts Reference may show similar products or products with additional processing.