#116 LEAD90

Custom Bike

#116 LEAD90Custom Report

I built this scooter chopper for fun around 2001, based on a Lead 90 that I received as a gift.

I removed the exterior, tilted the neck, modified the seat rail, and lowered the vehicle height.

At the time, I was extremely short on money, so I made it using only leftover parts I had on hand, things I got in trades, and parts I received as gifts.

The only things I bought were the turn signals, the battery, and the lens for the tail lamp.

It was my commuter vehicle at the time. It’s easy to ride, with good suspension movement in the front and back, and it’s about knee-high.

 

Cookie consent is required to display this video.

Custom List

FrontHandlebars, F forks, headlights, etc.

Front Area

◯The front area where the neck is extremely lowered and the vehicle height is reduced.


Headlight

7 inch Lucas Type Headlight Case Black

◯A deliberately unbalanced large headlight.


Handle/Handle Area

◯The handle is one-off. All switches are concentrated in easy-to-use positions.


Front Blinker

Small Rubber Winker Orange 4pcs Set


Speedometer

Mechanical speedometer φ48mm [No trip 1:4] General purpose #General-purpose parts


CenterTank, oil tank, seat, step, muffler etc.

Seat

◯The small solo saddle seat was hand-sewn and made from scratch. The height of the vehicle has been lowered by modifying the frame under the seat and changing the position of the rear shock mount.


Electrical Equipment

◯The electrical components are concentrated between the front of the engine and the frame. We have hidden each electrical component by bolting a plate, and made it easy to maintain.

IC blinker relay wide range specification

〇A wide-range turn signal relay that can be used without any problems with LED turn signals, supporting 1 to 150 watts. It can also be used as a replacement for the original relay.


Gasoline Tank

◯The gas tank was a worn-out one that I received from a Harley shop that I was indebted to. It’s a peanut tank that I meticulously repaired and installed.


Oil Tank

◯The oil tank is a one-off stainless steel. The cap is reused from the Sportster.


  • RearFenders, rear shocks, swingarms, etc.

    Rear Fender

    ◯The rear fender and rear fender stay are one-off pieces made from stainless steel.


    Tail Lamp

    ◯The tail lamp is a one-off production made of stainless steel and aluminum. It got bent around the number plate because a neighborhood kid ran into it with his bicycle.


    RearTurn Signal

    Small Rubber Winker Orange 4pcs Set

    ※Parts Reference may show similar products or products with additional processing.